Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
7. Open clips -Arrows A- and remove line -Arrow B-.
8. Open clip (brake assist system) -Arrows C- and remove line -Arrow D-.
9. Open clip (firewall) -Arrow A- and remove line -Arrow B-.
10. Press out the rubber sleeve (firewall) to the inside -Arrows C-.
Remove main wire harness - dashboard area and centre console
Removing Main Wiring Harness - Engine Compartment On Right
Remove right front wheel housing liner
Remove right front main headlight.
1. Push in latch -b- on connector for sensor -a- until it is felt to engage -Arrow A-.
2. Release locking mechanism latch -b- -Arrow B- and pull connector off the sensor -a- -Arrow C-.
3. Remove line together with lock carrier support -Arrow D-.
4. Turn bulb holder (wheel housing) slightly and remove -Arrow A-.
Only for vehicles with tyre pressure monitoring system
5. Release connector on antenna for tyre pressure monitoring system -Arrow B- and pull it off -Arrow C-.
Remove front apron.