Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
10. Turn steering gear -arrow- to the rear by approx. 90-100°
11. Unclip the coolant hoses in the wheel housing from the retaining clip. Then carefully guide out steering gear -see figure- through the left wheel
housing.
Installing steering gear
Warning: Risk of accident due to malfunction in PSM control range if steering-angle sensor is not calibrated or is incorrectly calibrated.
-
Possibility of serious injury or material damage.
-
Calibrate steering-angle sensor with wheels in straight-ahead position using the Porsche System Tester.
-
If steering wheel has been removed, ensure that airbag spiral spring is in center position.
Information
-
When topping up or filling in Pentosin, make sure that it does not come into contact with the coolant hoses. To avoid overflow caused by
overfilling, observe the instructions.
-
If coolant hoses come into contact with Pentosin, clean them thoroughly with water IMMEDIATELY!
-
Replace visibly swollen coolant hoses.