Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Information
-
The left clamp of the joint boot must be clamped so that the clamp lug -arrow- is in line with the steering pinion.
-
The right clamp of the joint boot must be clamped so that the clamp lug -arrow- points horizontally with the front axle carrier (suspension
subframe) in the direction of travel.
-
Failure to do this can lead to constrictions on the left-hand side in the vicinity of the feed and return lines and on the right-hand side in the vicinity
of the heat shield.
Fit joint boot (not twisted) and secure with new clamps -arrow- (use pliers for hose clamp NR.74).
Check the joint boot is not worn (cracks, slots) and that sealing surfaces are clean.
When fitting the ball joints, ensure that the conical seats are clean. Remove dirt or grease on conical seats, e.g. with a lint-free cloth. Do not use
cleaning agent/solvent.
Observe airbag safety instructions.
Install airbag unit for driver.
Observe notes on steering-gear center position in the section on front track adjustment.
Calibrate steering-angle sensor.
Observe correct tightening torques.