Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
6. Carefully pull the joint boot -see figure- outwards until the axial joint is accessible.
7. Disassemble axial joint -arrow- from the steering rack using open-jawed wrench insert a/f 38 NR.95-2 for torque wrench and remove the complete
tie rod.
Installing tie rod
-
Install in reverse order.
-
The tie rods are delivered preset as an assembly (tie rod/tie rod joint).
-
If the joint boot is to be used again, before installing inspect for wear (cracks, slits) and check that sealing surfaces are clean.
-
Identify position of tie rod joint on the (pre-) set tie rod and, in order to fit the joint boots and the small clamp, remove/fit lock nut and tie rod
joint.
-
During installation, insert new sealing rings -arrow- on the steering gear. Take care not to damage the sealing ring when fitting the joint boot.