Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Rear Knuckle: Service and Repair
WM 425219 Removing and installing rear wheel bearing housing (wheel carrier)
Preliminary work
Caution:
Increased risk of accidents if the wheel carrier is raised improperly!
-
Danger of injury and risk of damage to property.
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-
When raising the suspension, use a suitable intermediate layer (hard rubber).
-
Do not damage the brake cover plate.
1. Loosen axle nuts (wheel-side drive shaft fastening). (Do not remove them!) This prevents the drive shaft from slipping out when removing the
wheel bearing housing. Actuate the brake while doing this.
2. Raise the vehicle and remove wheel.
Removing rear wheel bearing housing (wheel carrier)
Wheel bearing housing with wheel hub and brake disc