Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Pressing in front-axle bearing at the front
9. Attach the tools as shown in the illustration and press in the bearing.
Information
Observe correct tightening torques.
10. Carefully lift the suspension subframe until the installation position is reached. Fit threaded joint on suspension subframe bearing.
11. Mount anti-roll bar on the connecting link.
12. Remove the spindle.
Replacing bearings for carrier, rear FA
Information
If a suspension subframe bearing is replaced, the other bearings must also be checked for cracks or other signs of damage.
1. Engage the spindle at the eyelet on the engine transverse bar at the side where you want to replace the bearing. Guide the spindle through the lower
trailing arm and tighten the spindle slightly so that the spindle is slightly tensioned.
2. Loosen the suspension subframe bearings on both sides. Loosen the spindle carefully until there is sufficient clearance for using the press-out tool.
Tools for pressing out front-axle bearings at the rear
3. Press out suspension subframe bearing.