Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
-
Push the rubber stop -2- up fully into the protective sleeve -3-.
-
Slide the cap into the protective sleeve -see figure- and pull the lip carefully over the cap.
Fitting cap into protective sleeve
2. Place the bottom concave washer (grey) -see figure- together with the bottom support -see figure- at the correct position (not twisted).
Fitting bottom concave washer into bottom support
At the correct position means that the two individual parts are fitted precisely together.
3. Place the top concave support -see figure- together with the top support -see figure- at the correct position (not twisted).
Marking and fitting top concave support with top support at correct position
At the correct position means that the two individual parts are fitted precisely together.
Assembly
Caution:
Increased risk of accidents due to spring tensioning.
-
Danger of injury and damage from springs jumping out.