Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
5. Once the concave support is positioned and aligned, the center lines -A- and -B- must be parallel. No. 1 -1- shows the connection of the connecting
rod from the stabilizer to the spring strut.
Concave support assembly
6. Once the mount is positioned, fit the new lock nut. Screw the lock nut onto the piston rod until approx. 1 to 2 threads are visible above the lock
nut. Then tighten with double-arm torque wrench 15 - 65 Nm (48 ftlb.) NR.93.
7. Complete the following steps to ensure that the protective sleeve (rear-axle spring strut in figure) -see figure- is seated correctly:
Fitting protective sleeve in top spring strut
-
Push the protective sleeve -arrow- up fully and clip it into the concave support.
-
Push the protective sleeve -arrow- down fully and clip it to the shock absorber with the cap (audible click).
Fitting protective sleeve in bottom spring strut