Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-799007.png)
-
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised using a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm ±10 mm corresponds to
vehicle position.
-
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
-
Screws and nuts are Dacromet-coated and must not be greased.
-
Grease axle nut with a little Optimoly TA aluminium paste only at mounting-face ring.
-
Grease the toothing of the drive shaft slightly with aluminium paste Optimoly TA.
-
Drive shafts must not be left hanging from the joint stop! Tie up.
-
Use new screws and lock nuts.
-
The wheel bearing seat must be free of grease.
-
Observe correct tightening torques.
1. Fit the wheel bearing (tools).
Check that the bearing seat -arrow- is clean and the surface is in good order. There must be no scores, grooves or deformations.
