Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Pressing in transmission mount
5. Press the calibrated mount -2- into the transmission cross member using the workshop press. When doing so, make sure the mount is aligned with
the transmission cross member.
5.1.
To do this, place tool T10214/1 under the opening in the transmission cross member. The mount is at the correct installation position when the
tool T10214/2 can move freely.
Tool moving freely
6. Unscrew tool T10214/3 from the mount.
Unscrewing tool
Information
When pressing in the mount, the mount may not be seated evenly in the transmission cross member.
7. Tool T10214/3 must be repositioned on the projecting side and the mount must be pressed in flush until it is installed evenly in the transmission
cross member.
Subsequent work for transmission mount
Information
Always observe the exact work sequence when installing/removing the transmission cross member.