Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Information
-
The adaptation values of the Tiptronic control unit must be reset using the Porsche System Tester when replacing/renewing the wire harness.
1. Install output shaft speed inductive pickup. To do this, screw in fastening screw -arrow-. - Tightening torque: 7.5 ftlb.
Output shaft inductive pickup
Information
-
Screws which are tightened with a torque angle must be replaced with new ones.
2. Install electrohydraulic control unit and screw in new fastening screws -arrows-. - Initial tightening: 6 ftlb. - Final tightening: 90 degrees.
Fastening screws for control unit
3. Plug in cable plug -2- for output shaft speed inductive pickup. -arrow-
Cable plug for output shaft inductive pickup
4. Install wire set for sensors through opening in the housing.
5. Insert ATF temperature sensor -7- and screw in fastening screw -arrow-. - Tightening torque: 7.5 ftlb.