Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-542005.png)
Information
-
The transmission cross member must be disassembled before the cardan shaft is installed.
1. Support transmission with transmission jack.
2. Install cardan shaft between ATF pan and exhaust system support.
Information
-
Screws which are tightened with a torque angle must be replaced with new ones.
3. Screw in new transmission cross member screws -B- on transfer gear holder. - Initial tightening: 50 Nm (37 ftlb.) - Final tightening: 90 angular
degrees
Transmission cross member
Information
-
Screws which are tightened with a torque angle must be replaced with new ones.
4. Screw in new cross member screws on body -A-. - Initial tightening: 50 Nm (37 ftlb.) - Final tightening: 90 angular degrees
5. Secure exhaust system to transmission cross member -center arrow- and body -outer arrow-. Observe tightening torques for exhaust system.
Exhaust system to cross member
Information
-
The color markings, match points -arrows- on the cardan shaft and on the all-wheel final drive flange must be aligned. This will neutralize the
residual imbalance of the components.
