Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Match points of front cardan shaft to front final drive
Information
-
To tighten the cardan shaft bolts, a second fitter should sit in the vehicle and block the drive train by actuating the brake.
Information
-
Screws which are tightened with a torque angle must be replaced with new ones.
6. Mount cardan shaft with new screws. - Initial tightening: 30 Nm (22 ftlb.) - Final tightening: 90 angular degrees
Front cardan shaft to all-wheel final drive
7. Mount cardan shaft with new screws -arrow- on the transfer gear. - Initial tightening: 30 Nm (22 ftlb.) - Final tightening: 90 angular degrees
Front cardan shaft to transfer gear
Subsequent work for front cardan shaft
1. Fit engine guard.