Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
-
Fit nut using screw-locking compound, e.g. Loctite 648.
3. Screw in new nut on output flange using special tool socket T10204. To do this, counter the flange with special tool arm bracket 3435. -
Tightening torque: 100 ftlb.
Tightening nut on output flange
4. Caulk nuts at the recesses in the output shaft.
Caulking nuts
Subsequent work for transfer box sealing ring
1. Install front cardan shaft.
2. Screw in new transmission cross member screws -B- on transfer box holder. - initial tightening: 50 Nm (37 ftlb.) - final tightening: 90 angular
degrees
Transmission cross member
3. Screw in new cross member screws on body -A-. - initial tightening: 50 Nm (37 ftlb.) - final tightening: 90 angular degrees
4. Fix exhaust system to transmission cross member -center arrow- and body -outer arrow-. Observe tightening torques for exhaust system.