Cayman (987) F6-2.9L (2009)
Trunk / Liftgate Latch: Service and Repair
Removing and Installing Rear Upper Part of Lid Lock
Removing And Installing Rear Upper Part Of Lid Lock
Technical values
Preliminary work
Remove lining for rear lid. Refer to Removing and installing rear lid lining.
Removing rear upper part of lid lock
INFORMATION: Determine the installation position of upper part of lid lock to cover using marking and note down.
1. Open the rear lid.
INFORMATION: Fastening nuts must not be used again following removal.
2. Unscrew fastening screws -1- and remove rear lock upper part -2-.
Installing rear upper part of lid lock
1. Position rear lid lock upper part -2- and tighten fastening screws -1- slightly.
2. Adjust rear lid lock upper part -2- in relation to the lid according to the noted position; if necessary, centre left and right gaps.
3. Tighten fastening screws -1-. Tightening torque: 23 Nm (17 ftlb.)
4. Check lid function.
Checking lid functions
1. Close the rear lid and lock it.