Cayman (987) F6-2.9L (2009)
4. Remove residual adhesive -3- and clean contact surface of base plate -2-.
Installing base plate of roof transport system
INFORMATION: Contact surface of roof channel and base plate of Roof Transport System must be free of dirt and grease.
1. Apply adhesive -3- on the underside of the base plate.
2. Position base plate -2- of Roof Transport System in and parallel to the roof channel. Screw in fastening nut -1- from inside and tighten. Tightening
torque: 23 Nm (17 ftlb.)
3. Lightly spread adhesive -3- with a brush.
4. Patch new sealing face and damage to top-coat paint in area of base plate -2- with same colour as the vehicle.
5. Install A-pillar trim panel. Refer to Removing and installing A-pillar trim panel.
6. Install roof joint cover strip. Refer to Removing and installing roof joint cover strip.