Cayman (987) F6-2.9L (2009)
2.3.1
Mask the outer edges of the rear lid (left side --> Figure 11-A-, right side --> Figure 11-B-) and along the beading joint seal, if necessary (-->
Figure 12-arrows-) with adhesive tape.
2.3.2
Cut into the beading joint seal up to the edge of the rear lid (--> Figure 12-arrows-). To do this, carefully go along the edge of the rear lid
vertically as far as the beading joint seal with a spatula.
2.3.3
Remove the beading joint seal for the inner/outer panel of the rear lid on the inside across its entire width (--> Figure 12 -arrows-) as far as
the adhesive tape using a spatula.
2.4
Treat all bores with corrosion protection and then paint the bores to match the vehicle's color code using a touch-up stick (--> Figure 13).
Paint the visible part of the beading joint seal with a touchup stick.
2.5
Clean the surface of the rear lid and remove the protective covering (paper or film) from the luggage compartment.
Use a vacuum cleaner to remove metal chips.