Cayman (987) F6-2.9L (2009)
Oil suction pump for cylinders 1 - 3
7. Remove tandem pump for cylinders 4-6. Unscrew four Torx screws M6 (micro-self-locking) -1-. Pull off the vacuum line on pump -2-. Remove
pump and replace O-rings and micro-self-locking screws.
Tandem pump side 4 - 6
Removing camshaft-engine removed
Removing camshafts
Caution
Risk of damage due to particles of dirt.
^
Danger of material damage due to blocked oil bores/oil ducts.
-> Absolute cleanliness is essential when working on the engine.
-> Lay removed engine parts on a clean base and make sure to cover them.
-> Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
Caps
1. Remove the plastic caps on the cylinder head. Press a small screwdriver into the center of the piercing point of each cap and lever out the caps.
2. Turn the engine at the assembly support so that the cylinder bank to be worked on stands vertically upwards.