Cayman (987) F6-2.9L (2009)
/f6-2.9l/Page-202009.png)
Chain tensioner, cylinders 1 - 3
Information
^
To make it easier to remove the bearing cover, spray the sealing surface with anti-rust agent.
7. Loosen M12 hexagon collar nut (a/f 22) on bearing cover for intermediate shaft with special tool assembly tool 9673/1 and screw it off ->
Threaded joint with collar nut on bearing cover for intermediate shaft.
Threaded joint with collar nut on bearing cover for intermediate shaft
8. Unscrew the three M6 x 20 fastening screws (coated) on the intermediate-shaft flange. Replace screws during installation and clean thread in
crankcase.
Information
^
Remove bearing cover using special tool puller 9673. If this is not available, lever the bearing cover out carefully with two screwdrivers so as not
to damage the sealing surfaces. Turning several times to the left and right loosens the bearing cover.
^
After removing the bearing cover, do not press the threaded bolts of the intermediate shaft.
9. Position special tool puller 9673 at the bearing cover grooves and secure by turning the locking lever anti-clockwise.
Puller on bearing cover: view when removed
10. Pull the slide hammer on the puller a number of times against the stop nuts while countering the tool at the same time with the other hand.
