Cayman (987) F6-2.9L (2009)
Removing bearing cover
11. If the puller is not available, lever the bearing cover out carefully using two screwdrivers (or angle screwdrivers). Move the bearing cover a
number of times to the left and right to make levering easier. Do not damage the sealing surfaces.
Levering out bearing cover
Installing bearing cover for intermediate shaft
Installing bearing cover for intermediate shaft-up to engine number 62.504094
Caution
Risk of damage due to particles of dirt.
^
Danger of material damage due to blocked oil bores/oil ducts.
-> Absolute cleanliness is essential when working on the engine.
-> Lay removed engine parts on a clean base and make sure to cover them.
-> Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
Information
^
Clean working area of bore for bearing cover and crankcase thoroughly using acetone or solvent naphtha.
1. Before installing the new bearing cover, check the fitted bore (axial attachment surface, bore chamfers) on the crankcase for sharp edges and burrs.
They should be removed with an oilstone or a polishing cloth. Remove any existing residue and clean the bore with a clean cloth soaked in solvent
naphtha or acetone.
Information
^
Replace bearing cover or sealing ring for bearing cover.
Information
Always observe specified engine number range.
2. Grease fitted bore in crankcase and new bearing cover (with new sealing ring) with special grease Optimoly MP3 (available from Porsche Parts
Service) and place bearing cover in position.
Information
^
Replace collar nut M8 x 1 and coated M6 screws for bearing cover.