Cayman (987) F6-2.9L (2009)
Lifting cylinder head cover from above
Lifting cylinder head cover from below
8. Remove the plastic caps.
Information
Make sure that it is cleaned thoroughly and that residual sealing compound is removed completely. Even the smallest particles can block up oil bores.
9. Clean the sealing faces on the cylinder head cover and cylinder head thoroughly (use a brass or nylon brush, a clean and lint-free cloth soaked in
acetone). All residual sealing compound in the cylinder head and on the cover must be removed before assembly.
Additional work steps on cylinder bank 4-6:
-
A tandem pump is installed on side 4-6 instead of the oil suction pump. Pull off the vacuum line on the pump -2-. Replace O-rings and
micro-self-locking screws -1-.
Tandem pump side 4-6