Cayman (987) F6-2.9L (2009)
Information
After pulling in the sealing ring, leave assembly tool 9699 in place for about one minute so that the sealing lip can settle into position on the
crankshaft flange.
7. To position the crankshaft sealing ring correctly on the crankshaft flange, turn at the hexagon (a/f 19) of the device in a clockwise direction as far
as it will go -figure-. Let the tool in place for about one minute.
Inserting sealing ring using tool 9699
8. Remove tool. Loosen the large hexagon-head bolt and the two inner hexagon-head bolts alternately on the crankshaft flange until the tool can be
removed.
9. Check whether the sealing ring is properly seated and aligned. To do this, measure at four points, offset by 90°, from the flywheel attachment
surface on the crankshaft flange to the sealing ring (outer radius). -> Dimension: 13 mm
10. Leave supporting sleeve on the tool following assembly to protect the edges of the tool. Carefully lift off the sleeve at the bore with a small
screwdriver to remove it.
Support ring on insertion tool
Subsequent work for crankshaft sealing ring on flywheel side
Subsequent work for crankshaft sealing ring on flywheel side
Manual transmission:
1. Install double-mass flywheel.
2. Install clutch.
3. Install manual transmission.
Tiptronic:
4. Install drive plate for converter.
5. Install automatic transmission.