Cayman (987) F6-2.9L (2009)
1. Unscrew the fastening screw -1- for the condenser line and pull the line out of the condenser.
2. Unclip holder for line and remove the line.
3. Unscrew the fastening screw -2- for the line to the compressor and pull the line out of the compressor line.
4. Pull the line out of the line holder and take it out.
Installing compressor-condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
-
When loosening or tightening the refrigerant lines with line connections, always counter with the special tool assembly tool 9822 if possible.
-
When loosening or tightening the refrigerant lines with connections to air-conditioning components (e.g. condenser), always counter with a size 21
open-ended wrench if possible.
1. Clip line into the line holder at the top and engage it in the rubber mounting.
2. Insert compressor-condenser line into the line to the compressor and fasten with the fastening screw -2-. - Tightening torque: 14 Nm (10.5 ftlb.)
3. Close and engage holder for rubber mounting.
4. Insert compressor-condenser line into the condenser and fasten it with the fastening screw -1-. - Tightening torque: 14 Nm (10.5 ftlb.)
Subsequent work