Cayman (987) F6-2.9L (2009)
Always replace the O-ring -3- between the reservoir -1- and hydraulic pump -5-.
Make sure that the reservoir -1- is fitted without tension on the hydraulic pump -5-.
Sealing ring on reservoir
Leaks can occur if the O-ring -3- becomes jammed.
2. Fit the reservoir on the hydraulic pump.
2.1.
Fit the reservoir on the hydraulic pump without tension.
2.2.
Drive in straight pins.
Reservoir for hydraulic pump
Secure the straight pins by putting a drop of Loctite in the bores of the hydraulic pump -2- (-arrows-).
Drive in the straight pins towards the back of the hydraulic pump -2- using a suitable mandrel that will not widen the bore hole.
2.3.
Fit holder -1- for hydraulic pump -2-.
Holder for hydraulic pump