Cayman (987) F6-2.9L (2009)
Cross member
Sensor:
Unscrew M6 nut securing sensor to control arm and disengage linkage.
Pull off electric connection.
Cross member:
Pull electric plug connections and lines out of the holders.
Unscrew screws -4a- and remove cross member -4-.
5. Remove stabilizer on rear-axle carrier side section.
Unscrew screws -2a- and remove stabilizer -2- by tilting it backwards.
6. Remove eccentric threaded joints (toe and transverse control arm) at rear axle carrier side section.
Eccentric threaded joint, rear-axle carrier side section
6.1.
Remove toe eccentric threaded joint between transverse strut and rear-axle carrier side section.
Mark the basic position of the toe eccentrics on the rear-axle carrier side section -see Arrow-.
6.2.
Remove camber eccentric threaded joint between toe control arm and rear-axle carrier side section.
Mark the basic position of the camber eccentrics on the rear-axle carrier side section -see Arrow-.
7. Remove rear-axle carrier side section.
Unscrew screws -3- and remove rear-axle carrier side section.
Installing