Cayman S (987) F6-3.4L (2008)
Installing halfshaft flange
Installing halfshaft flange
1. Replace square sealing ring in mounting saddle.
2. Check halfshaft flange for burrs and sharp edges on the transmission end of the shaft and deburr if necessary.
Note:
To avoid damaging the sealing ring in the transmission, the halfshaft flange must be guided carefully into position by hand.
3. Carefully insert halfshaft flange into the transmission.
4. Screw in fastening screws for mounting saddle.
5. Fit left drive shaft on transmission side. To do this, screw in the six Allen screws joining each drive shaft and transmission flange and tighten
screws. Counter at the wheel or activate the parking brake to avoid simultaneous turning.
Subsequent work
Subsequent work
1. Top up oil for final drive.
2. Fit support plate.
3. Lower the vehicle.