Panamera S (970) V8-4.8L (2010)
Lifting wheel carrier (air suspension)
*
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
*
Screws and nuts are Geomet-coated and must not be greased.
*
Grease the toothing of the drive shaft slightly with aluminum paste Optimoly TA.
*
Drive shafts must not be left hanging from the joint stop! Tie up.
*
Use new screws and lock nuts.
*
Use correct tightening torques and torque angles.
1. Raise anti-roll bar using transmission jack and place the bearings into the bearing seats.
WARNING
Wheel bearing housing raised incorrectly
*
Risk of squashing
*
Risk of damage to components
-> Wear personal protective gear.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
Information
PDCC chassis:
*
Steel flexi-pipes are particularly sensitive to kinking and crushing.
*
Treat the steel flexi-pipes with great care when securing the anti-roll bar.
*
Make sure that the steel flexi-pipes are not subject to any mechanical loads during the following operations.
2. The front-axle support is installed in reverse order to removal.
Subsequent work
1. Install front underbody panel.