Panamera S (970) V8-4.8L (2010)
3. Pull seal down off the sheetmetal flange.
Installing front rubber seal for front door
1. Fit new seal at the top of the front edge. The cut-out on the rubber seal for the front door must follow the contours of the front face of the window
shaft seal.
2. Affix seal.
2.1. Extend protective film with adhesive tape -1- .
2.2. Pull off extended protective film on the top edge and pull it out under the seal. Press the seal on at the same time.
3. Press in moulding seal at the front edge of the door.
4. Check that moulding seal is secure and that the surface is flush.
Subsequent work
1. Install door.