Panamera S (970) V8-4.8L (2010)
Installing line between compressor and connection point
INFORMATION:
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
Wet the O-rings of the refrigerant lines with refrigerant oil.
Do not open the plugs for the lines and connections until shortly before installation.
Close off all lines and connections using suitable plugs during removal.
1. Position the refrigerant line.
2. Connect the refrigerant line at the connection point.
3. Screw in the fastening screw -5- at the connection point.
-
Tightening torque: 14 Nm (10.5 ftlb.)
4. Screw in the fastening screw on the bracket for the line between the compressor and connection point.