Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-801003.png)
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.
-
The replacement date and mileage must be documented and the booklet must be stamped with the dealer s stamp.
1. Position airbag triggering unit on the centre tunnel and secure with the three fastening nuts -1- .
-
Tightening torque: 9 Nm (6.5 ftlb.)+10 %-15 %
2. Connect electric plug connection.
2.1. Connect electric connector -arrow- .
2.2. Lock locking bar on the connector as far as it will go -b- .
2.3. Close the lock on the connector -a- .
Subsequent work
Subsequent work for airbag triggering unit
1. Install centre console.
2. Connect the battery and carry out instructions after connecting the battery.
3. If the airbag triggering unit was replaced, the values/coding must be written back into the control unit again.
