Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-589140.png)
5. Loosen rubber sleeve in the left battery box, remove it by pushing it towards the underbody and carefully remove the entire wire harness.
Installing sub-part for rear left underbody (PASM)
1. Installation is performed in reverse order.
INFORMATION:
Select a place for the joint where there is enough space to join all the lines present.
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The procedures
are described in detail in the Repair kit for Cayenne wire harnesses NR.155-2.
Crimping samples must be prepared before beginning work.
Allocation of lines - see wiring diagram.
2. Once you have installed the sub-part, crimp the line in area -x-.
