Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-589197.png)
3. Make sure that all fastenings on the wire harness are released and carefully remove the wire harness by pulling it towards the underbody.
Installing sub-part of fuel level sensor at the rear left
1. Installation is performed in reverse order.
INFORMATION:
Select a place for the joint where there is enough space to join all the lines present.
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
INFORMATION:
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The procedures
are described in detail in the Repair kit for Cayenne harnesses NR.155-2.
Crimping samples are to be prepared before beginning work.
INFORMATION: Allocation of lines - see wiring diagram.
2. Crimp the lines in area -x-.
