Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-652003.png)
Fastening screws on hydraulic pump
8. Carefully remove the hydraulic pump to the side by turning it.
Installing hydraulic pump
Information
*
In vehicles without Servotronic, the hydraulic system must be flushed with approx. two liters of Pentosin.
*
The hydraulic system must be bled following repairs. The vehicle must be lowered onto the wheels for this.
*
Only use Pentosin CHF 202 to fill the hydraulic system.
*
Check the hydraulic fluid level.
*
Replace sealing rings.
*
Observe correct tightening torques.
Information
*
Make sure not to damage the radiator grilles.
1. Carefully position the hydraulic pump from the side.
2. Carefully fit the three fastening screws -2- at the front and the fastening screw -3- at the side of the hydraulic pump and then tighten all screws to
the specified tightening torque.
Fastening screws on hydraulic pump
3. Fit the pressure pipe -4- and intake pipe -5- at the hydraulic pump.
(Slide the hose for the intake pipe firmly onto the connecting piece for the hydraulic pump.)
