Alliance/Encore L4-1721cc 105 CID (1985)
Fluid Filter - A/T: Technical Service Bulletins
A/T - Revised Filter Installation Procedure
SUBJECT:
Transmission Oil Filter Revised Installation Procedure
NO.: 21-62-89 REVISION A
GROUP:
TRANS.
DATE:
Oct. 8, 1990
MODELS:
1983 - 87
BODY CODE:
KX - Alliance/Encore
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 21-62-89 WHICH SHOULD BE REMOVED FROM YOUR FILES. THE
FILTER ATTACHING BOLT TORQUES HAVE BEEN CORRECTED.
REVISED SERVICE PROCEDURE:
Because of major differences in the mounting points, appearance and dimensions of the MB1 and MB3 automatic transaxle service replacement oil filter,
PN T0734655, the installation procedure has been revised. In addition, a Filter Kit PN 83505742 has been released. The kit contains the following.
Filter Kit PN 83505742
1 - Filter
PN T0734655
1 - Bolt
PN J3001607
1 - Spacer
PN J5001254
1 - Seal
PN T3065118
1 - Instruction Sheet
PN JS001707
Please make reference of this Technical Service Bulletin 21-62-89 Rev. A on page 70 in your T.A.M. Automatic Transaxle Service Manual
dated August, 1986.
This TSB applies to all MB1 automatic transaxle and all MB3 up to MB3-107, Fabrication # 7942 and MB3-108, Fabrication # 233.
REPAIR PROCEDURE:
1.
Drain fluid and remove the automatic transaxle oil pan.
Figure 1
2.
Remove the two bolts retaining the oil filter to the valve body and remove filter, Figure 1.
3.
Remove and discard one valve body bolt as shown in Figure 1.