Torque wrench settings (page 2 of 2)
- Make
- Rover
- Model
- 600 620 Diesel Repair Manual Supplement
- Year
- 1995–1999
- Section
- Torque wrench settings
EngineTorque wrench settings · page 2 of 2
Engine LH mounting
| 12 mm nut | 70 Nm |
| 10 mm nuts | 45 Nm |
| Front beam bolts | 69 Nm |
| Centre beam bolts | 55 Nm |
| LH radius rod to lower arm bolts | 105 Nm |
| RH radius rod to lower arm bolts | 105 Nm |
| Lower tie rod, sump to front beam bolts | 85 Nm |
| Gear change steady bar bolt | 60 Nm |
| Lower ball joint to hub nut*** | 50 Nm |
| Suspension damper fork pinch bolt** | 44 Nm |
| Suspension damper fork lower nut and bolt** | 65 Nm |
| Road wheel nuts | 110 Nm |
| Engine RH mounting support plate: | |
| Nuts | 35 Nm |
| Bolts | 45 Nm |
* Tighten in sequence ** Full weight of engine must be on mounting before tightening nut ***Align to slot in nut
Parts & tools for this job For 1995 Rover 600
- PARTEngine gasket setSearch: Rover 600 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.