9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
10. Pull out the hydraulic lines from the hydraulic cylinder and remove the hydraulic cylinder.
IMPORTANT: Mark the hydraulic lines and their connection on the hydraulic cylinder as they must not get mixed up.
11. If the right-hand main cylinder is being changed, the main cylinder position sensor must also be removed. Use a screwdriver to carefully loosen the
two position sensors from the main cylinder. Move the hydraulic line to one side at the same time.
IMPORTANT: Cables to hydraulic lines and position sensors must be refitted as they were earlier or there will be a risk of them being
damaged when the soft top and soft top cover are operated.