9-5 Linear Sport Wagon (9600) L4-2.3L Turbo (B235) (2002)
12. Undo the following connectors: ignition discharge module, injectors, Manifold absolute pressure sensor, mass air flow sensor and Turbo pressure
sensor.
13. Loosen the cable and bend them to one side.
IMPORTANT
Secure each injector clip with a narrow cable tie. Make sure that it is correctly fitted and then tighten it. If this is not done, the injectors could come loose
from the fuel rail during the flow test.
14. Clean the area round the injectors with compressed air.
15. Remove the fuel rail retaining bolts.
16. Disconnect the pressure regulator vacuum hose.
17. Carefully praise loose the rail using 2 crowbars or similar tool.
18. Carefully lift the rail up and away.
19. Plug the nozzle orifices.
To fit
NOTE: Lubricate the O-rings with acid-free vaseline to facilitate assembly.