9-7X L6-4.2L (2008)
and Inspection/Camshaft Cover Cleaning and Inspection).
Installation Procedure
1. Install a new camshaft cover seal.
2. Install new rubber ignition control module seals.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the camshaft cover and secure with the cam cover bolts.
Tighten the camshaft cover bolts to 10 Nm (89 in. lbs.).
4. Install the ignition control modules and secure the modules with bolts.
Tighten the ignition coil bolts to 10 Nm (89 in. lbs.).
5. Connect the ignition control module electrical connectors.
6. Install the fuel injector electrical connectors.
7. Install the engine electrical harness housing (1).
