9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
1
Fit the gear selector cable with rubber grommet.
2
Fit the selector cable to the selector cable bracket.
3
Lightly lubricate the selector arm ball and fit the selector cable to the transmission.
Note: Do not lubricate the selector cable cup. If there is grease in the cup, the ball may become detached.
Rubber mounted selector cable is attached with clips.
Tightening Torque, Rubber Grommet: 8 ± 1 Nm.
4
Fit the gear indicator cover and indicator lamp.
5
Fit selector lever covers and release buttons.
6
Fit the storage pocket.
7
Fit the air duct.
8
Fit left-hand and and right-hand side trim.
9
Fit the battery tray.
10 Fit battery and leads.
11 Adjust the selector cable. See: Adjustments