9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Speedometer Gear, A/T: Service and Repair
NOTE:
^
Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
^
Due to different designs, there are several ways to remove the speedometer drive
Removal
1. Remove the speedometer cable or the electronic sensor from the speedometer drive.
-
First remove any bracket from the electronic sensor.
2. Types:
-
Design 1: Use a screw driver to press up the toothed ring.
-
Design 2: Tap the locking pin out of the gear case.
-
Design 3: Undo the screw securing the speedometer drive.
3. The speedometer drive can now be removed.
-
Remove the drive from its sleeve.
-
Remove the O-ring and seal from the sleeve.