900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
Downshift Switch: Adjustments
1. Remove the resonating chamber.
2. Depress the pedal (possibly with the aid of a pedal clamp) until it just reaches the kick-down switch. Check that it moves smoothly and easily
down to the kick-down switch. If it does not, it could be because the throttle cable is incorrectly adjusted.
3. Check that the throttle is now wide open. If it is not, adjust the throttle cable casing.
NOTE: To provide a "kick-down feeling", the force applied when pressing the accelerator further down is absorbed by a spring in the throttle
cable.
4. Release the accelerator and check that there is some slack in the throttle cable. If there is not, remove the lower section of the dashboard and carry
out the adjustment necessary to provide a little slack in the cable by means of the adjusting screw on the upper part of the pedal.
5. Start the car and check the idling speed.
6. Install the lower section of the dashboard.
7. Install the resonating chamber.
IMPORTANT: After adjustment, the throttle position should be checked using an ISAT scan tool.
