Astra L4-1.8L (2009)
6. Remove the cover plate from wheel bearing unit.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note:
*
Note installation position.
*
Clean thread and insert bolts with locking compound.
1. Install the wheel bearing unit.
*
Place the cover plate on the wheel bearing unit.
*
Slide the wheel bearing unit with the cover plate onto the axle shaft and place onto steering knuckle.
*
Install the 3 new bolts.
Tighten the bolts to 90 Nm (67 lb ft) plus 30 degrees plus 15 degrees.