Astra L4-1.8L (2009)
Note: Ensure that wiring harness is correctly attached in all brackets and clips in order to prevent damage to wiring harness.
2. Route the wiring harness.
*
Clip the wheel sensor wiring harness in the retaining clip (1).
*
Connect the wheel sensor wiring harness.
3. Install the axle shaft with the new nut.
Tighten the axle shaft nut to 150 Nm (111 lb ft), undo 45 degrees, then tighten to 250 Nm (185 lb ft)
Counter-hold against wheel hub with J 28733-B /KM-6610 and KM-956-1.
4. Install the brake rotor. Refer to Front Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Front Brake Rotor Replacement).
5. Install the front wheel.
Tighten the front wheel bolts to 110 Nm (81 lb ft).