Astra L4-1.8L (2009)
3. Install the wiring harness of the pressure sensor (atmospheric pressure) to the fuel filler tube.
Install the 3 cable ties.
4. Install the right rear wheel housing inner paneling.
*
Tighten the 2 nuts to 3 Nm (26 lb in).
*
Tighten the 2 bolts to 3 Nm (26 lb in).
5. Install the right rear wheel.
6. Lower the vehicle halfway.
Tighten the right rear wheel to 10 Nm (89 lb in).
7. Install the fuel filler pipe.
1. Remove the fuel filler pipe cap.
Tighten the bolt to 6 Nm (53 lb in).
2. Install the rubber cover.
3. Install the fuel filler pipe cap.
Tighten the bolt to 6 Nm (53 lb in).
8. Lower the vehicle all the way.
9. Connect the battery.
Connect the ground clamp to the ground terminal.
Tighten the ground clamp nut to 5 Nm (44 lb in).
10. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
11. Close the hood.
