Astra L4-1.8L (2009)
6. Remove the supply line from the steering gear.
Installation Procedure
1. Place the supply line (2) with the new seal ring on the steering gear.
2. Place the supply line with the new seal ring on the electro-hydraulic supply unit.
3. Place the return line (1) with the new seal ring on the steering gear.
4. Place the return line (1) with new retaining strap to electro-hydraulic supply unit.
5. Clip the holder (3) for the supply and return lines to the steering gear.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Tighten the supply and return lines on the steering gear.
Tighten to 30 Nm (22 lb ft).
7. Tighten the supply line on the electro-hydraulic supply line.
Tighten to 30 Nm (22 lb ft).
8. Fasten the return line with the retaining strap and J 22610 to the electro-hydraulic supply unit.
9. Install the front frame. Refer to Front Frame Replacement (Removal) (See: Suspension/Subframe/Front Subframe/Service and Repair/Front
Frame Replacement (Removal))Front Frame Replacement (Replacement) (See: Suspension/Subframe/Front Subframe/Service and Repair/Front
