Astra L4-1.8L (2009)
Steering Gear: Service and Repair
Steering Gear Replacement (TRW without NR1, NS1, NS2)
Steering Gear Replacement (TRW without NR1, NS1, NS2)
Special Tools
*
KM-6004-2 Tie Rod Wrench
*
J 22610 Keystone Clamp Pliers
Removal Procedure
Note: To remove the steering gear, the front frame must be removed.
1. Remove the front frame. Refer to Front Frame Replacement (Removal) (See: Suspension/Subframe/Front Subframe/Service and Repair/Front
Frame Replacement (Removal))Front Frame Replacement (Replacement) (See: Suspension/Subframe/Front Subframe/Service and Repair/Front
Frame Replacement (Replacement)).
2. Remove the engine damping block bracket (1) at the rear of the engine damping block.
3. Remove the holder (2).
Note: Oil runs out, use drain pan.
4. Place a drain pan under the power steering line connections and remove the supply line (3) and return line (4) from the steering gear.
Note: Note the wiring route.
5. Disconnect the wiring harness for the steering from the front frame.