ION L4-2.2L VIN F (2004)
2.
Once the tabs are trimmed, the tabs must be primed and painted to protect against corrosion. (For priming, refer to SI Document ID # 158787. For
painting, refer to SI Document ID # 216200.)
Sunroof Installation Procedure
1.
With an assistant, position the sunroof module assembly into the studs located on the roof ring.
Notice:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints,
lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping
force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts
and systems.
2.
Install the two center bolts which secure the sunroof module assembly to the roof and tighten the bolts by hand.
3.
Install the remaining sunroof module bolts.
Tighten
Tighten all of the bolts to 10 N.m (89 in.lbs).