ION L4-2.2L VIN F (2004)
1. Bench bleed the master cylinder.
2. Check to ensure that the master cylinder-to-vacuum brake booster seal (1) is properly seated into the recessed groove on the master cylinder.
3. Install the master cylinder to the vacuum brake booster.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the brake master cylinder mounting nuts.
-
Tighten the nuts to 20 Nm (15 ft. lbs.).
5. Remove the caps from the brake pipe ends.
6. Connect the brake pipe fittings (1) at the master cylinder.
First Design ISO Flare to 19 Nm (14 ft. lbs.)
Second Design Double Inverted Flare to 18 Nm (13 ft. lbs.)
7. Install the brake master cylinder auxiliary reservoir.