ION L4-2.2L VIN F (2004)
8. Install the underhood electrical center bracket to the vehicle and install the electrical center (1) into position on the bracket.
9. Connect the electrical connector to the brake fluid level sensor, then press forward on the CPA tab of the connector to secure.
10. Install the cover to the underhood electrical center.
11. Connect the negative battery cable.
12. Bleed the hydraulic brake system.
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Caution: Refer to Brake Fluid Irritant in Service Precautions.
Notice: When adding fluid to the brake master cylinder reservoir, use only Saturn P/N 21013073, or equivalent DOT-3 brake fluid from a clean,
sealed brake fluid container. The use of any type of fluid other than the recommended type of brake fluid, may cause contamination which could result
in damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components in Service Precautions.
Removal Procedure