ION L4-2.2L VIN F (2004)
10. Check to ensure that the master cylinder-to-vacuum brake booster seal (1) is properly seated into the recessed groove on the master cylinder.
11. Install the master cylinder with the brake pipes, to the vacuum brake booster.
Notice: Refer to Fastener Notice in Service Precautions.
12. Install the brake master cylinder mounting nuts.
-
Tighten the nuts to 20 Nm (15 ft. lbs.).
13. Secure the brake master cylinder pipes to the 6-position pipe clip along the frame rail.
14. Install the brake master cylinder auxiliary reservoir.
15. Install the underhood electrical center bracket to the vehicle and install the electrical center (1) into position on the bracket.